ARE-310
The standard model of the non-vacuum THINKY MIXER series. Provides simultaneous processing of mixing, dispersing and deaeration of high-viscosity materials.
- Supports a wide range of materials, including high-viscosity materials and nano fillers
- The 2 modes of mixing and deaeration achieve dispersion and deaeration of high-viscosity materials in a small amount of time
- Cold-insulated, heat-resistant adapter enables support of various material characteristics
- Wide variety of adapters for using various containers
- Memory and step-operation functions for controlling and executing operating conditions
- Unique air-cooling system
Feature
The centrifugal force of over 400G enables simultaneous processing of mixing, dispersion, and deaeration of various materials from low to high viscosities for general purposes.
Furnished with a deaeration mode that enables high-precision deaeration, this model shows excellent performance in deaeration of high-viscosity adhesives and materials whose viscosities are increased by added fillers. A wide variety of materials and uses are supported by using adapters for various containers. It is employed for production or research and development where small amounts of materials are prepared.
Specification
Specification
| Unit Dimensions/ Unit weight | H390×W300×D340£¨mm£©Approx. 21kg |
|
Maximum Capacity*1
*1£ºTotal mass to mount on the cup holder, including materials, containers, and adapters.
|
310g |
|
Standard Container*2
*2£ºContact us because the actual volume of mixing may vary depending on the containers, materials, and conditions.
|
300 ml resin container |
| Power Supply | Voltage: Single-phaseAC 120 V ± 10 %, 50/60 HzPower consumption:Approx. 50 VA (standby)Max 900 VA (operation) |
| Accessories | Instruction Manual × 1AC cable (including 3P adapter) × 1,HDPE 300 ml container × 3,150 ml container × 1,Adapter for 150 ml container × 1(including 1 rubber ring)Key to unlock door during power failure (unit rear) × 1 |
