Solvent Recovery Unit (GAS410)
Solvent Recovery Unit (GAS410) Solvent Recovery Unit (GAS410) Organic Solvent Recovery Unit Granulating & Spray Drying Selangor, Malaysia, Kuala Lumpur (KL), Puchong Supplier, Distributor, Supply, Supplies | Renetech Sdn Bhd
Highly safe N2 gas sealed circulation system, which can be operated with a spray dryer unit
 
Features of Solvent Recovery Unit (GAS410)
  • The Inert N2 Gas Sealed System is used to prevent external discharge when combined with a spray dryer (ADL311SA or GB-210A) when using an organic solvent.
  • Dehumidifier (Freezer) integrated in GAS410. No extra Freezer/ dehumidi-fier equipment needed
  • Compressor included, no need for a separate compressor to operatethe spray dryer ADL311SA when using organic solvent samples
  • Flammable or toxic solvents can be processed by combining a N2 gas sealed circulation system and a solvent recovery system (with freezer and capacitor)
  • Explosion safety with closed loop N2 inert gas system
  • Recovery of solvent to protect the environment and enable minimized pollution.
  • Drying of easily oxidized materials is possible
  • Supports low temperature drying of materials that easily deform with heat
  • No freezing risk due to organic solvent with aqueous solution mixtures which could cause damage to the closed loop GAS410 system
  • Spray drying and recovery of products and solvents are performed with meticulously devised safety measures
Specifications
Item Code 212774
Model GAS410
Solvent recovery system Capacitor + freezer
Circulating gas N2 gas (sealed circulation when connected to ADL311SA or GB-210A)
Circulating volume flow 0.12 to 0.65m3/min
Compressor (for spraying) Linear compressor integrated
Circulation blower Roots blower
Solvent recovery container 2L flask
Freezer Air-cooled condensation full-sealed type: 400W R404A
Solvent recovery mechanism Capacitor cooling mechanism
Filter Cartridge filter
Instruments Cooling trap temperature display monitor Filter differential pressure meter (Monitor for clogging of filter) O2 density display monitor Blower wind amount adjusting volume
O2 sensor Solid electrolyte (Zirconium) limit current type
Pump For circulation to measure Oxygen
Safety device O2 density meter, Flammable gas alarm, Electric leakage breaker, N2 gas forced introduction (when removing nozzles)
Required N2 amount 15 L/h at 0.1 MPa
Accessories Set of connection parts, anti-seismic clamps, interface cable, sample gas for gas alarm inspection, 2L flask
External dimensions£¨W×D×H mm£© 700×950×1500mm
Power Source 000V
Single phase AC200〜240V¡¡5A£¨15A£©
Weight 130kg
 
Maintenance and warranty
Conditions: temperature and humidity: 23 deg.C+/-5 deg.C, 65%RH+/-20% (no load)
External dimensions do not include protrusions.

Please leave your enquiry here, we will reply as soon as possible.


*only support gif, jpeg, jpg, png, pdf
Switch To Desktop Version